NUPROL Power - 11.1v LiPo 1300mAh 3S Deans [Rate 20C @ 26A] [Burst 40C @ 52A] - Stick

NUPROL Power – 11.1v LiPo 1300mAh 3S Deans [Rate 20C @ 26A] [Burst 40C @ 52A] – Stick

You will be taken to Amazon to checkout.

STATS – LiPo | 11.1v | 1300 mAh | 20C/40C @ 26A/52A (Cont/Burst) – Airsoft AEGs use the “Burst” flow rate to start the motor, and then the “Cont” flow rate to provide continuous discharge (check your owners manual to ensure the battery purchased meets the minimum flow rate (C) of your AEG) – this battery provides approximately 3 minutes of continuous discharge before running flat
LITHIUM POLYMER – LiPo batteries have an excellent size/weight to capacity ratio, allowing you to fire more shots with a smaller battery. LiPo batteries can be recharged at any charge level without damaging the overall capacity of the battery. LiPo batteries should not be “run-flat”, as this can damage the battery and effect overall charge ability. LiPo batteries MUST be charged with a LiPo Balance Charger. LiPo batteries should always be charge in a fire-retardant Safe-Charging-Bag
STANDARD – this battery is a common airsoft battery design, for fitment in the stock buffer tube of rear wired Airsoft Replicas. Always check the dimensions of the battery vs the battery compartment to ensure compatability

Categories: Airsoft Batteries, Airsoft Batteries 11.1V, Airsoft Shop

Description

STATS – LiPo | 11.1v | 1300 mAh | 20C/40C @ 26A/52A (Cont/Burst) – Airsoft AEGs use the “Burst” drift rate to start the motor, and then the “Cont” drift rate to provide continuous discharge (check your owners manual to verify the battery purchased meets the minimum drift rate (C) of your AEG) – this battery provides approximately 3 minutes of continuous discharge before running flat
LITHIUM POLYMER – LiPo batteries have a very good size/weight to capacity ratio, allowing you to fire more shots with a smaller battery. LiPo batteries may also be recharged at any charge level without damaging the overall capacity of the battery. LiPo batteries must not be “run-flat”, as this can damage the battery and effect overall charge ability. LiPo batteries MUST be charged with a LiPo Balance Charger. LiPo batteries must At all times be charge in a fire-retardant Protected-Charging-Bag
STANDARD – this battery is a common airsoft battery design, for fitment in the stock buffer tube of rear wired Airsoft Replicas. At all times check the dimensions of the battery vs the battery compartment to verify compatability
DEANS (T) – this battery is suitable for Airsoft Replicas the usage of a Deans (T) battery connector
QUALITY CONTROL – NP Power batteries are produced at an ISO 9000 Quality Keep an eye on accredited manufacturing plant and shipped at an optimal charge rate of ≥60% to offer protection to against degradation when in transport/ storage