NUPROL Power – 7.4v LiPo 1600mAh 2S Deans [Rate 20C @ 32A] [Burst 40C @ 64A] – Stick

STATS – LiPo | 7.4v | 1600 mAh | 20C/40C @ 32A/64A (Cont/Burst) – Airsoft AEGs use the “Burst” go with the flow rate to start the motor, and then the “Cont” go with the flow rate to provide continuous discharge (check your owners manual to verify the battery purchased meets the minimum go with the flow rate (C) of your AEG) – this battery provides approximately 3 minutes of continuous discharge before running flat
LITHIUM POLYMER – LiPo batteries have a very good size/weight to capacity ratio, allowing you to fire more shots with a smaller battery. LiPo batteries can also be recharged at any charge level without damaging the overall capacity of the battery. LiPo batteries will have to not be “run-flat”, as this can damage the battery and effect overall charge ability. LiPo batteries MUST be charged with a LiPo Balance Charger. LiPo batteries will have to All the time be charge in a fire-retardant Protected-Charging-Bag
STANDARD – this battery is a common airsoft battery design, for fitment in the stock buffer tube of rear wired Airsoft Replicas. All the time check the dimensions of the battery vs the battery compartment to verify compatability
DEANS (T) – this battery is suitable for Airsoft Replicas the use of a Deans (T) battery connector
QUALITY CONTROL – NP Power batteries are produced at an ISO 9000 Quality Keep watch over accredited manufacturing plant and shipped at an optimal charge rate of ≥60% to offer protection to against degradation when in transport/ storage